如何在Ubuntu 16.04 / 18.04上初始化Centrino Wireless-N 1000？
我定期安装Ubuntu 16.04的更新，并且从论坛讨论中看来，似乎（或其他东西）已经击败了WiFi适配器 – 迅驰无线-N 1000.我在这里查找了一个类似的问题，但提供的解决方案没有为我工作。
请参阅下面的 – 几个网络命令的输出（我从这个论坛的其他post中查找了这些命令）。 任何解决此问题的指导？
谢谢
亲切的问候
**sudo lshw -C network** *-network description: Ethernet interface product: 82577LM Gigabit Network Connection vendor: Intel Corporation physical id: 19 bus info: pci@0000:00:19.0 logical name: enp0s25 version: 06 serial: f0:de:f1:3e:b9:db capacity: 1Gbit/s width: 32 bits clock: 33MHz capabilities: pm msi bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation configuration: autonegotiation=on broadcast=yes driver=e1000e driverversion=3.2.6-k firmware=0.12-1 latency=0 link=no multicast=yes port=twisted pair resources: irq:24 memory:f2500000-f251ffff memory:f2525000-f2525fff ioport:1820(size=32) *-network DISABLED description: Wireless interface product: Centrino Wireless-N 1000 [Condor Peak] vendor: Intel Corporation physical id: 0 bus info: pci@0000:02:00.0 logical name: wlp2s0 version: 00 serial: 8c:a9:82:19:f9:6a width: 64 bits clock: 33MHz capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless configuration: broadcast=yes driver=iwlwifi driverversion=4.13.0-43-generic firmware=39.31.5.1 build 35138 latency=0 link=no multicast=yes wireless=IEEE 802.11 resources: irq:28 memory:f2400000-f2401fff *-network description: Ethernet interface physical id: 2 logical name: bnep0 serial: 70:f3:95:4e:c1:be capabilities: ethernet physical configuration: broadcast=yes ip=192.168.44.130 multicast=yes **nmcli dev** DEVICE TYPE STATE CONNECTION enp0s25 ethernet unavailable -- wlp2s0 wifi unavailable -- lo loopback unmanaged --
**ifconfig** bnep0 Link encap:Ethernet HWaddr 70:f3:95:4e:c1:be inet addr:192.168.44.130 Bcast:192.168.44.255 Mask:255.255.255.0 inet6 addr: fe80::d657:9693:821e:bc6/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:14269 errors:0 dropped:0 overruns:0 frame:0 TX packets:13030 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:11222734 (11.2 MB) TX bytes:1394169 (1.3 MB) enp0s25 Link encap:Ethernet HWaddr f0:de:f1:3e:b9:db UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) Interrupt:20 Memory:f2500000-f2520000 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:65536 Metric:1 RX packets:3774 errors:0 dropped:0 overruns:0 frame:0 TX packets:3774 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:321735 (321.7 KB) TX bytes:321735 (321.7 KB)
**dmesg | grep iwlwifi** shows messages such as Microcode SW error detected. Restarting 0x82000000. Loaded firmware version: 39.31.5.1 build 35138 Failed to run INIT ucode: -5 Unable to initialize device.